Are inline comments supported by uCNC?

[hmmueller]

Here is an example of a GCode line created by my GCode generator right now:

G01 X57.687 Y0.000 Z0.800(=0.800+0.794*[#51-2.000]+0.206*[#52-2.000]) F150.000

Is this supported by uCNC? - i.e., is this interpreted as

G01 X57.687 Y0.000 Z0.800 F150.000

? When I send a file with the upper line to uCNC 1.10 via UGS, sending (as well as the machine) stops after that line - but I do not know whether this happens because uCNC does not like it, or because UGS hiccups. UGS does not show any error message, neither an ALARM or the like from uCNC nor something indicating that it does not like the line itself, that's why I ask.

Thanks for enlightenment!

H.M.

[Paciente8159]

It should support inline comments.
Here

[hmmueller]

Thank you - then I'll open an issue with UGS.

[Paciente8159]

A simple test would be for you to send a command like that in a terminal and check if it responds with an ok statement

[hmmueller]

Yes - when I am near the CNC machine again, I'll do that.